- Robert E. Petersen Collection
- Ancient Firearms
- The Road to American Liberty
- Seeds of Greatness
- The Prospering New Republic
- A Nation Asunder
- The American West
- Innovation, Oddities and Competition
- Theodore Roosevelt, Elegant Arms
- World War I and Firearms Innovation
- WWII, Korea, Vietnam and Beyond
- For the Fun of It
- Firearms Traditions for Today
- William B. Ruger Special Exhibits
- Freedom's Doorway
Mauser (Leige, Belgium) Interim Model 1869/70 Bolt-Action Rifle, Model #2
This prototype rifle included several improvements over earlier Mauser designs, including a coil mainspring that was less succeptible to breakage than the earlier flat mainspring. The bolt was also re-worked to eliminate a split between the bolt handle and body that was prone to jam should foreign material lodge inside. The second of the "Interim" Mausers, this model also cocks on opening and possesses an extended cocking piece that allowed the rifle to be re-cocked without opening the action.
During 1869 and 1870, Paul Mauser worked to correct several design flaws that would prove detrimental to military use of the Norris-Mauser Model 1867/69 rifle. The split bolt handle incorporated into the earlier design could easily jam should dirt or snow lodge between the flat mainspring and the body of the bolt handle. Since it also acted as a hammer, the spring could break under these circumstances.
The Norris-Mauser also had no safety mechanism, and the rifle's bolt was of such close tolerances that mass-production could be problematic. Mauser's solution to these problems was to re-design the bolt in a way that was markedly different from that of his earlier rifle. The new bolt consisted of four pieces: head, body, cocking piece, and cocking piece nut that screwed onto the firing pin. The bolt handle was mounted on the locking lug. In addition, the earlier flat mainspring was replaced with a coil spring, and a safety mechanism mounted on the right rear of the receiver operated by engaging grooves cut into the locking lug.
Actually, this interim design consisted of not one but two different bolts, both of which possessed the features mentioned previously. The first cocked on closing and, owing to the small cocking nut, must be re-cocked after firing by turning the bolt. The second bolt cocked on opening, and, due to its longer cocking piece, could be re-cocked without actuating the bolt. In addition, the location of the bolt and safety mechanism differed between the two designs. There is no evidence that either of these were patented; rather, both were most likely prototype "proof-of-concept" arms.
The Prussian Government tested these "Interim Mausers," and this process revealed several problems. Foremost among these was in the operation of the safety mechanism, which was remedied by the adoption of the rotating safety common to later models. Other deficiencies were addressed in the design of the Model 1871 rifle, which became the first Mauser to be officially adopted by a European army when Prussia selected it as a replacement for the Dreyse Needle Gun.